This is a well thought out product that could be better with some changes.
First off my first use was repetitive cuts in 18mm plywood, it took minutes to setup with the stop system in place and every cut was square and true.
I was surprised that there are no pins supplied as standard for when you want to use it at 45 degrees?
The bits that I think could be improved is the top wind in clamp very similar to those used on flight cases but could be a bit more robust, having had these on flight cases they wear quite badly over time. the second change would be to replace the locator pins with a spaced rail, the knurl on the pins sometimes bites into the guide rail, also it only provides two points on contact in the channel.
In the sys container if the inserts for the repeat stop was cut inward away from the edge the stop blades could be left on without causing an issue.
Overall I have been impressed with the engineering and finish, small enhancements would make it even better.
Just makes the job so easy for repetitive making … another quality but of kit
Bought this router jig to repair a family dining table … absolutely did the job with ease … fantastic but if kit
Well made but not the best user friendly.
No instructions , I had to keep looking up on YouTube. Well could be cheaper
Hi. Glad you like them but I thought I would let you know that the instructions are available on line in our instruction manual page. You would received a card with scan link to them.