I have an outrigger attached to my double length ultra mft bench. It has been attached using 2 sets connectors, 1 set in the upper track took and bench corner. The second set is connected with the lower bench corner hole, and the inside corner of the bench has connectors in both the upper and lower tracks !
It took some work and patience to fit the slide in piece into the lower track, but it was worth the effort. I simply inserted the small diameter end into a drill chuck and used emery cloth to cut the diameter of the slide in piece until it fit.
Once fully assembled, my double length bench with the outrigger on the right side of the cut strip, is absolutely rock solid! My bench , at the right side now measures 48ā. Everything that I have put together thus far has been amazing !!
This works great for the angle stop and the benchdog fence. Now it is faster and easier to make all my cuts, wish I bought this sooner. If you have a festool angle stop and a benchdog fence, this is a great addition
I cannot fault it. It has speeded up my workflow and hugely improved the accuracy of my cuts using Bosch FSN tracks.
The facility to add on extenders is novel and inspired and I found it was well worth investing in one for longer rips.
Great and useful addition Wondering if there's a way to add compression. just sits in the dog hole.
if overtime . hol expand slightly due to constant use most of the pressure is on a single dog hole . and no way to tighten it down
The CSC Fence and Adaptor Plate is a fantastic product; I'm very satisfied with the quality. Thank you for more such high-quality products, especially for Festool! :-)
Greetings from Switzerland,
Gaetano