THE NEW MK2 PARALLEL GUIDES - THE MK1 UPGRADE VERSION for tracks like Festool, Makita, Kreg ACS, Milwaukee Fuel, Evolution and Triton. You must have the MK1 version for this to work. Do...
THE NEW MK2 PARALLEL GUIDES - THE MK1 UPGRADE VERSION for tracks like Festool, Makita, Kreg ACS, Milwaukee Fuel, Evolution and Triton. You must have the MK1 version for this to work. Do not buy this option if you do not have a Benchdogs PG system
The new improved MK2 PG System has a number of upgrades, Precision Machines Aluminium Stops and new improved narrow cut is a one-time calibration for both parallel cuts and narrow cuts. The fence has a dual scale for both Parallel and Narrow cuts.
Set the stop on one side for parallel cuts or for Narrow Cut Rips, turn the stop 180 degrees and fit the narrow cut attachment to the underside of the stop then set the size needed and place the NCR attachment to the edge of the board allowing you to produce repeatable precise cuts.
Our precision machined parallel guide system is compatible with Festool, Makita and Triton tracks and is a simple system to connect. Slide in and tighten the thumbscrews, set your stop and away you go.
Available in Metric or Imperial
330 Sections can achieve cuts of the following
Section 1 - 520mm With Sections 1 & 2 - 850mm With All Sections - 1180mm
500 Sections can achieve cuts of the following
Section 1 - 690mm With All Sections - 1180mm
You will receive: 330mm (1180mm Maximum Length) 1 x Set / pair - Rails (6x 330mm) 2 x Aluminium Stops 2 x Stainless Steel Narrow Cut Attachments
You will receive: 500mm (1180mm Maximum Length) 1 x Set / pair - Rails (4x 500mm) 2 x Aluminium Stops 2 x Stainless Steel Narrow Cut Attachments
Quality bit of kit! Came well packaged and when opened it didn’t disappoint. Felt ’solid’ in hand and on checking the angles were spot on. Looking forward to using it in my next project. I have bought from benchdogs previously and had the same experience. I recommend.
Very high quality in fit and finish. Only thing missing in my opinion would be a card with a QR code that linked to the assembly video. I viewed such a video prior to purchase so I knew where to find it. The quick link would just be a welcome helper.
